Skip to main content

Mask Respirator

By
 This is a type of mask that has a high possibility to prevent the person using the mask from getting the virus

 Nontoxic glue recommended, however glue is not really necessary, the mask can be used with any filter media. ideally electrostatic charged polypropylene. A 360 degree drum is unlimited to any given amount of layers needed for protection with a low rate of current and enough flow to breath comfortably. the inner drum should be spooled with cotton being the secondary buffer filter. Both drums are featured with hose clamping profiles to provide a reliable seal around the filter and to cradle the bounded rubber-bands. The reed valves are finished with a .5mm thick cutout of latex or silicone which would be installed with a small screw and washer. Last but not least the borders are to be lined with a soft neoprene stripping for a conformed seal around the face. CAUTION! if you are infected, this type of mask is unsafe for other people unless reed valves are plugged!



SOURCE: https://grabcad.com/library/mask-respirator-1

Comments

Post a Comment

Popular posts from this blog

Ventilaid breathing device Mk III

By
VentilAid is a very simple, yet effective device for non-invasive ventilation. It is especially projected to help patients suffering from COVID-19. VentilAid helps breathing, prevents alveoli from collapsing and monitors patients health. Major features Compactness and mobility Universal power supply Automatic function in CPAP and BiPAP modes FiO2 do 70%, Up to 70% FiO2 Pressure up to 15 cm H2O (wi th a greater technical capablity of up to 30cm H2O) The device adapts to the breathing rhythm of the patient https://www.ventilaid.org/ventilaid-breathing-device-mk-iii/
Post a Comment
Read more
By
Mask Strap Efficiency  This simple but useful tool is designed to make face masks less painful to wear for medical workers treating coronavirus patients. The part is made by printing a set, and then connecting with any filament which will also set its width.  In this way, the filament which is needed for a single print is reduced and 18 sets on a 250x250mm print bed are allowed. Small protrusions on both sides of the plastic buckle hold the mask strap and the mask strap does not exert painful pressure on the ears. References: Michael B. ( 2020 ). Prusa Printers. Mask strap efficiency print. https://www.prusaprinters.org/prints/28959-mask-strap-efficiency-print
Post a Comment
Read more
By
COVID19 Glove Remover Hook to remove the gloves after use. Designed to hang on a door, without installation. After removing both gloves, we can throw them away by holding the hook at the back, without having to make contact with the gloves. There are three models for different door thicknesses: 35mm, 40mm and 45mm link: https://grabcad.com/library/covid19-glove-remover-1
Post a Comment
Read more