Infrared Thermometer

An infrared thermometer is a sensor that consists of a lens to focus the infrared (IR) energy on to a detector, which converts the energy to an electrical signal that can be displayed in units of temperature after being compensated for ambient temperature variation.

This configuration facilitates temperature measurement from a distance without contact with the object to be measured (non-contact temperature measurement). As such, the infrared thermometer is useful for measuring temperature under circumstances where thermocouples or other probe type sensors cannot be used or do not produce accurate data for a variety of reasons.

Some typical circumstances are where the object to be measured is moving; where the object is surrounded by an EM field, as in induction heating; where the object is contained in a vacuum or other controlled atmosphere; or in applications where a fast response is required.

You can easily access the design 3d: https://grabcad.com/library/digital-thermometer-3
About everthing : https://docplayer.biz.tr/8455460-Uzaktan-temassiz-ates.html

Comments

Ventilaid breathing device Mk III

VentilAid is a very simple, yet effective device for non-invasive ventilation. It is especially projected to help patients suffering from COVID-19. VentilAid helps breathing, prevents alveoli from collapsing and monitors patients health. Major features Compactness and mobility Universal power supply Automatic function in CPAP and BiPAP modes FiO2 do 70%, Up to 70% FiO2 Pressure up to 15 cm H2O (wi th a greater technical capablity of up to 30cm H2O) The device adapts to the breathing rhythm of the patient https://www.ventilaid.org/ventilaid-breathing-device-mk-iii/

Mask Strap Efficiency This simple but useful tool is designed to make face masks less painful to wear for medical workers treating coronavirus patients. The part is made by printing a set, and then connecting with any filament which will also set its width. In this way, the filament which is needed for a single print is reduced and 18 sets on a 250x250mm print bed are allowed. Small protrusions on both sides of the plastic buckle hold the mask strap and the mask strap does not exert painful pressure on the ears. References: Michael B. ( 2020 ). Prusa Printers. Mask strap efficiency print. https://www.prusaprinters.org/prints/28959-mask-strap-efficiency-print

COVID19 Glove Remover Hook to remove the gloves after use. Designed to hang on a door, without installation. After removing both gloves, we can throw them away by holding the hook at the back, without having to make contact with the gloves. There are three models for different door thicknesses: 35mm, 40mm and 45mm link: https://grabcad.com/library/covid19-glove-remover-1

3D Printing/Medical Masks-Devices/COVID19

Search This Blog