Medical Face shield for doctors and nurses

Have a 3D Printer? You Can Use It to Make Face Shields for Medical Workers

There are many types of face shields, but the type most medical workers are seeking is a piece of clear, curved plastic suspended in front of the wearer’s face by a headband. It helps stop bodily fluids and droplets, whether from a patient’s cough or a medical event such as a birth, from reaching the wearer’s eyes, nose, or mouth. A shield is usually meant to provide secondary protection when used with a primary piece of personal protective equipment (PPE) such as a face mask.

Link- https://thewirecutter.com/blog/3d-printer-coronavirus-face-shield/

by-
Makame Mahmud
ID: 110410309

Comments

Ventilaid breathing device Mk III

VentilAid is a very simple, yet effective device for non-invasive ventilation. It is especially projected to help patients suffering from COVID-19. VentilAid helps breathing, prevents alveoli from collapsing and monitors patients health. Major features Compactness and mobility Universal power supply Automatic function in CPAP and BiPAP modes FiO2 do 70%, Up to 70% FiO2 Pressure up to 15 cm H2O (wi th a greater technical capablity of up to 30cm H2O) The device adapts to the breathing rhythm of the patient https://www.ventilaid.org/ventilaid-breathing-device-mk-iii/

Mask Strap Efficiency This simple but useful tool is designed to make face masks less painful to wear for medical workers treating coronavirus patients. The part is made by printing a set, and then connecting with any filament which will also set its width. In this way, the filament which is needed for a single print is reduced and 18 sets on a 250x250mm print bed are allowed. Small protrusions on both sides of the plastic buckle hold the mask strap and the mask strap does not exert painful pressure on the ears. References: Michael B. ( 2020 ). Prusa Printers. Mask strap efficiency print. https://www.prusaprinters.org/prints/28959-mask-strap-efficiency-print

COVID19 Glove Remover Hook to remove the gloves after use. Designed to hang on a door, without installation. After removing both gloves, we can throw them away by holding the hook at the back, without having to make contact with the gloves. There are three models for different door thicknesses: 35mm, 40mm and 45mm link: https://grabcad.com/library/covid19-glove-remover-1

3D Printing/Medical Masks-Devices/COVID19

Search This Blog